Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision |
| brad [2024/09/11 19:52] – mvaughns | brad [2024/09/11 19:59] (current) – mvaughns |
|---|
| |{{:mboxapart.jpeg?300|}}\\ This is the wood cut already and ready to be nailed together, here we are holding the nail to the edge of the wood to give a visual of how deep the nail will go inside of the corner of the wood. We want to use long enough nails so that the wood stays together and intact so they it does not separate. | | |{{:mboxapart.jpeg?300|}}\\ This is the wood cut already and ready to be nailed together, here we are holding the nail to the edge of the wood to give a visual of how deep the nail will go inside of the corner of the wood. We want to use long enough nails so that the wood stays together and intact so they it does not separate. | |
| |
| |{{:mboxclamped.jpeg?300|}}\\ using| | |{{:mboxclamped.jpeg?300|}}\\ We recommend that you clamp your wood together for beginners for safety and flexibility. Go ahead and turn on the air compressor and make sure that it runs until it automatically turns itself off, pull the hose from the compressor and take it to your station, then push the air hose end onto the tip of the nail gun where the nozzle meets the gun; Now your nail gun is ready to use. Hold the wood together, get a clamp and position your nail gun in the area and angle you want the nail to go in. We can go ahead and put 2 nails in each side of your wood, you want to be careful about hitting a nail that is already in the wood as it can cause ricochet or nail bending. Push the nail gun in to the wood, press the trigger, and pull away after the nail has been inserted into the wood. There will be a loud sound when this happens so you want to make sure you have your hearing protection on. After nailing place the gun down on the counter.| |
| |
| |{{:mfinishes.jpeg?300|}}\\ captionnnn| | |{{:mfinishes.jpeg?300|}}\\ Here we have the final product! After you have finished with the nail gun, pull the air hose away from the brad nailer by pulling the metal claps back from the nail gun and away from your person. Wind up the air compressor hose and wrap it around the air compressor.| |
| |
| |
