Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| ender_3_maintenance [2025/01/23 04:35] – [Ender-3 Maintenance] jpelot | ender_3_maintenance [2025/01/23 04:36] (current) – [Bed Leveling] jpelot | ||
|---|---|---|---|
| Line 36: | Line 36: | ||
| Configure > Store Settings | Configure > Store Settings | ||
| to save your changes. You should have the printer re-level the bed anytime you adjust the Z-Offset. | to save your changes. You should have the printer re-level the bed anytime you adjust the Z-Offset. | ||
| + | ---- | ||
| ===== Long-term Maintenance ===== | ===== Long-term Maintenance ===== | ||
| This section is for maintenance tasks that should be performed periodically. | This section is for maintenance tasks that should be performed periodically. | ||
| ===== Common Issues ===== | ===== Common Issues ===== | ||