Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| ender_3_maintenance [2025/01/23 04:31] – [Bed Leveling] jpelot | ender_3_maintenance [2025/01/23 04:36] (current) – [Bed Leveling] jpelot | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| This document is intended as a manual aimed at Hackberry lab assistants for guidance on maintaining the ever-growing fleet of printers. Knowledgeable lab assistants are encouraged to add their wisdom as more issues arise and new problems are solved. | This document is intended as a manual aimed at Hackberry lab assistants for guidance on maintaining the ever-growing fleet of printers. Knowledgeable lab assistants are encouraged to add their wisdom as more issues arise and new problems are solved. | ||
| + | ---- | ||
| ===== Short-term Maintenance ===== | ===== Short-term Maintenance ===== | ||
| Maintenance tasks that should be performed at regular intervals. When the printers are being used heavily, these should be done every night at the start of the shift. | Maintenance tasks that should be performed at regular intervals. When the printers are being used heavily, these should be done every night at the start of the shift. | ||
| Line 36: | Line 36: | ||
| Configure > Store Settings | Configure > Store Settings | ||
| to save your changes. You should have the printer re-level the bed anytime you adjust the Z-Offset. | to save your changes. You should have the printer re-level the bed anytime you adjust the Z-Offset. | ||
| + | ---- | ||
| ===== Long-term Maintenance ===== | ===== Long-term Maintenance ===== | ||
| This section is for maintenance tasks that should be performed periodically. | This section is for maintenance tasks that should be performed periodically. | ||
| ===== Common Issues ===== | ===== Common Issues ===== | ||